Using the CNC the first thing was to design the figure in VectorWorks as it shows in the following picture

Screen Shot 2015-02-19 at 14.14.27

After adjusting the file in CAM, we exported it in Gcode to uploaded into the CNC software.

We secure the material with screws, and adjust the zero.

2015-02-18 13.37.26

2015-02-18 13.46.34





After checking everything is right, we start the CNC.

2015-02-18 13.47.28

Because my material wasn’t flat it jumped when the outside contour wasn’t done, damaging the piece a little. For next time I definitely would use double sided tape to secure it.
2015-02-18 14.36.22Finally I decided to give it a paint layer

2015-02-18 16.03.15

Leave a Reply